The function of this system is to remove the finished part from the cavity of the mold. A thread is molded on the outside of the part. This requires the part to be unscrewed in order to remove it from the mold.
There are four (4) parts to be unloaded at the same time. When the mold opens, the unloader descends into the cavity of the mold and locates over the hex portion of the part. Once engaged, the unloader will begin to unscrew the part from the cavity while moving away from the mold at a fixed rate equal to the pitch of the thread. Once the part is clear of the mold, it will fall into four (4) discrete chutes in order to segregate the parts by cavity mold number.
Hours: Mon - Fri 8am – 5pm
7245 16th Street East , Suite 114
Sarasota, Florida 34243
Phone: (941) 351-6330
Copyright © 2018-2020 Sunshine Automation & Tooling. All Rights Reserved. SUNSHINE AUTOMATION & TOOLING and its logo are trademarks and service marks owned by Sunshine Tool, LLC. All other trademarks used on this site are the property of their respective owners. Site design and maintenance by www.DesignStrategies.com.